…and to make it look more naturally I painted the 3D model with acrylic paint.FULL&.CGAXIS-3D Models C-oLLec.tion 05-13-2016 In case you have problems during as your model falls over use a raft.ģD model of the Zugspitze, 5.5 cm x 6 cm x 0.8 cm, 50 min print duration, 0.1mm Layer height, Prusa i3 MK2 printerģD model with a primer layer and a layer of white. This way, the details will be printed best (left image). When you print the model in the vase-mode, you need to align it vertically. The main reason is that the printing time is reduced by almost the half and there will be no blobs at the end of the layers. Why print the topographic map with the vase-mode?
Lonely mountain 3d model download#
You will receive the Download link via email within 5 to 10 minutes. With the OBJ file you can create a coloured 3D print or use the topographic model in a 3D software. The scale of the height can be adjusted on the next page.ĭownload the single colour STL file for normal FDM and SLA printer. In the following image all 4 steps are marked that are required to create a topographic STL file. The service is free, you only need to register with your email. You can create the STL file on the website
STL file is too detailed an can be, depending of the selection, several GB large.Colored 3D model (OBJ-Datei) will be exported.
Lonely mountain 3d model free#
Nevertheless, the page is helpful and free of charge. An option would be to use a program such as Meshmixer to adjust the model to your own wishes and needs.ĭuring the generation of large models, Terrain2STL crashed sometimes. Unfortunately, the area for the model cannot be adjusted in wigth or height. The height of the ground can be set in the section “Water and Base Settings” -> “Base Height”. Vertical Scaling: Higher values increase the differences in heights in the 3D model You can fine tune the details of the 3D model to the map in the section “Model Details”.īox Scaling Factor: The marked are can be increased with this option, however, details in the 3D model will be reducedīox Rotation: The marked area can be rotated.This is the area that will be used for the 3D model. A red square will be shown in the middle of the map. Click on “Center to View” under Location.
Lonely mountain 3d model how to#
A topographic map is a map that is used to display exactly the landform (topography) and other visible details of the earth’s surface.